ProForm Grip Body Filler, 3Liter. Grip Body Filler is formulated to offer superior grip to bare metal,aluminum, SMC, fibreglass, galvanized metal and zinc treated steel. It is easy to sand and is stain resistant. Hardener included. 3 L / .8 Gallon. Working time 5 min. Sanding time 20 min. Directions for use:

SURFACE PREPARATION:

• 1. Surface must be free of rust, wax, silicone, grease, dirt and other contaminants.


• 2. Clean metal surfaces with Wax and Grease Remover. Wipe dry while the surface is still wet.


• 3. Grind surface using 36 grit (or finer) disc.


• 4. Use clean dry air and blow surface free of dirt.


• 5. For maximum adhesion, apply directly to bare metal.

MIXING DIRECTIONS:

Mixing Ratio: 2%. Mix 2% of cream hardener to PF 155. Using a non contaminated mixing board, mix  thoroughly until mixture is color consistent.

DIRECTIONS FOR USE:

• 1. Mix the desired quantity of product.


• 2. Apply mixed product using a clean spreader. Fill to desired level. Avoid filling depth greater than 6.5 mm (1/4").


• 3. Allow to cure thoroughly.


• 4. Break with 40-80 grit abrasive, and finish sand to desired contour. If required, use Pro Form finishing putty.


• 5. Topcoat with a premium quality primer.

11122