Proform FIBREGLASS RESIN, 1Gallon. "Fibre Resin" is a heavy, non-sag, general purpose resin that can be used on fibreglass and metal. It cures to a hard, non tacky surface that can be sanded or filed. Liquid hardener included.

Directions for use FIBREGLASS RESIN:

SURFACE PREPARATION:

1. Surface must be free of rust, wax, silicone, grease, dirt and other contaminants.

2. Clean metal surfaces with Wax and Grease

Remover. Wipe dry while the surface is still wet.

3. Prepare surface for application with 80 grit abrasive.

4. Use clean dry air and blow surface free of dirt.

MIXING DIRECTIONS:

Mixing Ratio: 2%. Mix 2% of liquid hardener to 11462. In a clean container, mix thoroughly until hardener is evenly distributed into the resin.

DIRECTIONS FOR USE:

1. Mix the desired quantity of product.

2. Wet cloth or matting material until saturated,

then form into position. For applications without

reinforcement, fill thickness should not exceed

6 mm (1/4") in depth.

3. Allow to cure thoroughly.

4. Sand to desired contour with 80 grit (or finer). If required, skimcoat with body filler or finishing putty.

5. Topcoat with a premium quality primer.

11462